Starting to Shop for Drag Radials for Spring

[Schullz51]

As the title says I'm getting antsy about getting to the track. Getting my car in november meant in the north east that drag strips are all but shut down around that time so I missed my opportunity.

Anyways, for the spring I want to be ready. I was wondering if anybody has information on fitment for Nitto NT05R's. I would want to get a nicer looking set of rear wheels to have them mounted on so I could just chuck them in the trunk drive to the strip switch them on and then go back to stock for the ride home. I was thinking of maybe the Avant Garde M359 19X9 or X10 and a NT05R of 305/35/19.

Would this work? Be too wide etc? I'm honestly horrible about wheel fitments and all the lingo as far as offsets etc.

Thanks all in advance.

[crashtestdummy81]

Be careful how much grip you aim for, it would seem that the drive shafts can't handle the full torque in first gear, potentially 6755 lb-ft.

check this thread:
http://f80.bimmerpost.com/forums/sho...ghlight=1200hp