[330xtrai]

I was playing around inpa and of course I screwed up and somehow I'm having an issue( car cranks but no start was getting the ews manipulation error) after doing a search I was supposed to use the ews program start value in inpa but in my inpa it doesnt work and give this error(picture attached). any help? I'll try it again later today. I was also getting 2 error that have to do with throttle. I also reset adaptations. let me know what to do. thanks

[Levanime]

try to synchronize dme and cas/ews

[330xtrai]

Originally Posted by Levanime

try to synchronize dme and cas/ews

That's what I was trying to do but I'm not 100 percent sure how to do it. Was trying thorough ews which is shift f6 on inpa and selecting program which gives me that error in the picture

[matteblue3er]

EWS alignment can be done through the DME or CAS submenus.

There is no sync.

[330xtrai]

Originally Posted by matteblue3er

EWS alignment can be done through the DME or CAS submenus.

There is no sync.

ok so I should basically click shift+f7 to open CAS then f2 for the alignment?

[matteblue3er]

Yes the same function is in both ECU submenus. They perform the same job but sometimes one or the other does not work. Try both.

[Terraphantm]

F1 should be to reset both modules to "0" in the rolling code table, and F2 should be for programming a new DME with the ISN.

[330xtrai]

Originally Posted by matteblue3er

Yes the same function is in both ECU submenus. They perform the same job but sometimes one or the other does not work. Try both.

Thank you got it fixed through the cas menu. Waited a few seconds after unplugging the cable and the remote then I started it perfectly.

[330xtrai]

Originally Posted by Terraphantm

F1 should be to reset both modules to "0" in the rolling code table, and F2 should be for programming a new DME with the ISN.

Thank you worked perfectly.

[Jozy]

we're blessed by terra's presence in e90post