07-30-2019, 02:39 PM | #1 |
New Member
0
Rep 6
Posts |
Engine light after jb4 install
So I’ve installed my jb4 bonnet open close doors lock the car put the keys far from the car and waited 10 minuets then I installed my jb4 everything was fine for about 50 miles then the engine light comes on but the cars driving normal so I cleared the fault code but it keeps coming back I’m so confused? The car is a x2 2.0i (b48)
101F01 Throttle valve opening angle pressure -- Ignore, tuner code 104302 absolute pressure sensor, intake manifold, plausibility, caster: pressure too low 101F02 throttle angle - intake manifold pressure, correlation: limit exceeded These are the codes that keep coming back |
Post Reply |
Bookmarks |
|
|