Hi,
I have already installed the physical alarm on my car, and got the clown nose blinking. I know I have yet to code the alarm to fully integrate it, but I had a few questions regarding the coding.
I know there are options that you are able to access after coding, and certain differences. However, I was wondering if anyone had a comprehensive list on the changes after coding versus just leaving it installed without coding. From what i have been reading, this is what i've noticed:
-Panic enable
-IDrive menu chirp enable on lock
After installing the alarm my clown nose has already been activated. Also, is it even necessary to code to have the alarm "function"? The reason i ask is, there have already been several occasions where my car's alarm was set off. My friend walked by my car when the windows were down, and the alarm went off. Also, it went of previously in a garage due to a loud exhaust (yes, it was a meet
)
Sorry if this has been covered in other threads, but i haven't found anything comprehensive regarding this topic quite yet.