Quote:
Originally Posted by mrpingu
You sure you are not missing any wire at any place?
TRSVC is camera.
Seems ICAM is not found that means it cannot be reached on the canbus3. So either the camera is not compatible or the canbus is not wired up corrrectly or the ecu is getting no power /turning on. Probably wire is not in place or wring pin somewhere. You should get ICAM up in esys to code after coding PMA & HU.
You can doulbe check partnumber of camera seems like over at the mini forum someone had similiar problem
https://www.minif56.com/threads/help...reply_top_post
|
Thanks... only wiring i can think off is that from BDC and R3 dont really match up
BDC pin 43 & 44 (note the order)
R3 PIN 16 & 3 (note the order)
as per pic earlier in thread... you can see blue and green wires are on different pins...
otherthen this, let me check HU wiring again...
Also no break in wiring to and from R3 and camera
appreciate help