Quote:
Originally Posted by NemoNeil
Not sure if I’m on the right track but after opening the wiring loom and looking for pins 43 and 44, they are already occupied.
So I don’t know where it says on the pack BDCBODY 8B stands CAN8 ?
Or shall I ignore the packet and follow the diagram posted by 678hug ?
Thanks for help so far.
|
Just an FYI, I disconnected the existing wires on 43 and 44 on the BDC body and replaced with the twisted pairs as per packet instrauction and car started procuding light failures and stuff.. so immediately put back the BDC as it was and back to normal now..
So i take this as it doesnt go to the BDC or at that connection...
I assume it needs to go to the R2 or the R3 interface in the boot.
But where is this and which one?
any help
Thanks