Quote:
Originally Posted by NemoNeil
So in my case I have yellow/white and solid yellow wires, would I install then on pins 9/22 on the R3 terminating resistor?
|
No I don't think so as you already have it prewired from factory.
Edit:
Quote:
Originally Posted by NemoNeil
So in my case I have yellow/white and solid yellow wires, would I install then on pins 9/22 on the R3 terminating resistor?
|
No I don't think so as you already have it prewired from factory. (but verify, you know the pin numbers, colors.)
What is important is that you follow the total scheme.
So you have 2 CANBUS wires from BDC to R3 (this one is probably wired from factory (green & Blue)
BDC pin 43 & 44 (note the order)
R3 PIN 16 & 3 (note the order)
From R3 you have 2 CANBUS Wires to Camera (c* or a24, depending on which diagram)
R3 pin 22 & 9 (note the order)
C* pin 7 & 8 (note the order)
From Camera to headunit you have
C* pin 1,2 & 5 (note the order)
A42 (HU) pin 21, 24 & 23 (note the order)
From C* to PDC/PMA unit
C* pin4
B41 (PDC) pin 9